First-Time Installation - Nortel 1110 Fundamentals

230 Nortel IP Softphone 2050
3
4

First-time installation

During the first-time installation, the two IP address parameters entered
either manually- or automatically, depending on the installation configuration.
They are as follows
•
•
Static IP address assignment
During the installation, enter the IP Softphone 2050 parameters manually
using the dialpad.
Enter the IP address, subnet mask, and default Gateway address. You
must also enter the Connect Server parameters including IP address, port
number, action, and retry count.
Dynamic IP address assignment:Partial DHCP
For a partial DHCP installation, you must provide, through the IP Phone
dialpad, the Connect Server parameters including: IP address, port number,
action, and retry count. Other parameters (IP Phone IP address, subnet
mask, and default Gateway) are obtained from the DHCP server.
Enter the IP Phone pass word, node ID, and TN manually, using the dialpad.
For more information about DHCP servers, see Converging the Data
Network with VoIP Fundamentals (NN43001-260).
Use
231)
Copyright © 2003–2007, Nortel Networks
.
Understand the three configuration modes from which you can
choose from as you proceed through the installation of the IP
Softphone 2050. The 2 configuration modes are
• Static IP address—see
230)
• Partial DHCP—see
DHCP" (page 230)
A DHCP server and DHCP relay agents, if required, must also be
installed, configured, and running.
Static IP address assignment
Partial DHCP
Procedure 43 "Installing an IP Softphone 2050 for the first time" (page
to install an IP Softphone 2050 for the first time.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
"Static IP address assignment" (page
"Dynamic IP address assignment:Partial
—End—