Nortel 1110 Fundamentals page 120

120 Nortel IP Phone 2004
Copyright © 2003–2007, Nortel Networks
.
Screen prompt
Data VLAN ID:
Data pBits (0-7, 8-Au)
PCUntagAll? (0-N, 1-Y)
PSK SRTP? (0-No, 1-Yes)
GARP Ignore? (0-No,1-Yes)
The IP Phone 2004 supports remote firmware upgrades through a
TFTP process and an automated UFTP process.
You are prompted to enter the TFTP Server IP address if you are
using a TFTP Server to download the current firmware.
The method to upgrade the firmware depends on the following Call
Server software:
• For Succession Release 3.0 or CS 1000 Release 4.0, the TFTP
Server is required to download the current firmware. Enter the
TFTP Server IP address at the prompt
• For CS 1000 Release 4.5, use either a TFTP Server to upgrade
the firmware (at the prompt accept the default entry of 0.0.0.0) or
UFTP to download the current firmware.
•
For CS 1000 Release 5.0, a Signaling Server provides the
firmware for the IP Phones. Check the Nortel Web site at
www.nortel.com
For Succession Release 3.0 and CS 1000 Release 4.0, the IP Phone
2004 searches for the TFTP Server for firmware upgrade. If the file
name specified in i2004.cfg is not the same as the current firmware,
the IP Phone downloads the file and upgrades the firmware. This
takes several minutes. When the upgrade is complete, the IP Phone
2004 reboots.
For further information about TFTP Server configuration, see
Appendix "TFTP Server" (page
The Enhanced UNIStim firmware download is supported on CS 1000
Release 4.5 or later. The Enhanced UNIStim firmware download
feature for IP Phones improves the delivery of new firmware to IP
Phones. For further information about Enhanced UNIStim Firmware
Download, see IP Line Fundamentals (NN43100-500).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Description
You are not prompted for Data
VLAN ID if Data VLAN is set to 0
for Auto.
Default 8 (for Au).
You are not prompted for Data
pBits if the PC Port is set to 0 for
Off or if 802.1Q is not enabled.
Default 0 (for No).
Default 0 (for No).
Default 0 (for No).
for updated firmware files.
533).