Configuring Ipv6 Pim-Dm Graft Retry Period; Configuring Ipv6 Pim-Sm; Ipv6 Pim-Sm Configuration Task List - 3Com MSR 50 Series Configuration Manual

1248 C 74: IP 6 PIM C
HAPTER V
Configuring IPv6
PIM-DM Graft Retry
Period
Configuring IPv6
PIM-SM
IPv6 PIM-SM
Configuration Task List
ONFIGURATION
To do...
Configure the interval
between state refresh
messages
Configure the time to wait
before receiving a new state
refresh message
Configure the hop limit value
of state refresh messages
In IPv6 PIM-DM, graft is the only type of message that uses the acknowledgment
mechanism. In an IPv6 PIM-DM domain, if a router does not receive a graft-ack
message from the upstream router within the specified time after it sends a graft
message, the router keeps sending new graft messages at a configurable interval,
namely graft retry period, until it receives a graft-ack from the upstream router.
Follow these steps to configure IPv6 PIM-DM graft retry period:
To do...
Enter system view
Enter interface view
Configure graft retry period
n
For the configuration of other timers in IPv6 PIM-DM, refer to
PIM Common Timers" on page
n
A device can serve as a C-RP and a C-BSR at the same time.
Complete these tasks to configure IPv6 PIM-SM:
Task
"Enabling IPv6 PIM-SM" on page 1249
"Configuring a BSR" on page
1250
Use the command...
state-refresh-interval
interval
state-refresh-rate-limit
interval
state-refresh-hoplimit
hoplimit-value
Use the command...
system-view
interface interface-type
interface-number
pim ipv6 timer graft-retry
interval
1261.
"Performing basic C-BSR
configuration" on page 1250
"Configuring a BSR
admin-scope region
boundary" on page 1251
"Configuring global C-BSR
parameters" on page 1251
Remarks
Optional
60 seconds by default
Optional
30 seconds by default
Optional
255 by default
Remarks
-
-
Optional
3 seconds by default
"Configuring IPv6
Remarks
Required
Optional
Optional
Optional