Configuring Ospfv3 Basic Functions; Prerequisites - 3Com MSR 50 Series Configuration Manual

1052 C 64: IP 6 OSPF
HAPTER V
Configuring OSPFv3
Basic Functions

Prerequisites

Configuring OSPFv3
Basic Functions
3 C
V ONFIGURATION
Task
"Configuring OSPFv3 Routing
Information Management" on page
1054
"Tuning and Optimizing an OSPFv3
Network" on page 1056
Make neighboring nodes accessible with each other at network layer.
■
Enable IPv6 packet forwarding
■
To configure OSPFv3 basic functions, use the following commands:
To do...
Enter system view
Enable OSPFv3 and enter its
view
Specify a router ID
Enter interface view
"Configuring OSPFv3
Route Summarization"
on page 1054
"Configuring OSPFv3
Inbound Route Filtering"
on page 1054
"Configuring Link Costs
for OSPFv3 Interfaces"
on page 1055
"Configuring the
Maximum Number of
OSPFv3 Load-balanced
Routes" on page 1055
"Configuring a Priority
for OSPFv3" on page
1055
"Configuring OSPFv3
Route Redistribution" on
page 1056
"Configuring OSPFv3
Timers" on page 1056
"Configuring the DR
Priority for an Interface"
on page 1057
"Ignoring MTU Check
for DD Packets" on page
1057
"Disabling Interfaces
from Sending OSPFv3
Packets" on page 1058
"Enabling the Logging
on Neighbor State
Changes" on page 1058
Use the command...
system-view
ospfv3 [ process-id ]
router-id router-id
interface interface-type
interface-number
Description
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Remarks
-
Required
Required
-