3Com MSR 50 Series Configuration Manual page 1273

Network diagram
Figure 367 Network diagram for IPv6 PIM-SSM configuration (on routers)
Eth1/0
Source
Router D
4001::100 /64
Device Interface
Router A Eth1/0
S2/0
POS5/0
Router B Eth1/0
POS5/0
Router C Eth1/0
POS5/0
Configuration procedure
1 Configure the interface IPv6 addresses and IPv6 unicast routing protocol for each
router
Configure the IP address and prefix length for each interface as per
Detailed configuration steps are omitted here.
Configure the OSPFv3 protocol for interoperation among the routers in the IPv6
PIM-SM domain. Ensure the network-layer interoperation among Router A, Router
B, Router C, Router D and Router E in the PIM-SM domain and enable dynamic
update of routing information among the routers through a unicast routing
protocol. Detailed configuration steps are omitted here.
2 Enable IPv6 multicast routing, and enable IPv6 PIM-SM on each interface
Router A
Eth1/0
POS 5/0
POS 5/2
POS 5/3 POS 5/1
POS 5/0
POS 5/0
Router E
POS 5/0
Eth1/0
IPv6 PIM-SM
Router C
IP address Device
1001::1/64 Router D
1002::1/64
1003::1/64
2001::1/64 Router E
2002::1/64
3001::1/64
3002::1/64
IPv6 PIM Configuration Examples
Eth1/0
POS 5/0
Router B
Interface IP address
Eth1/0 4001::1/64
S2/0 1002::2/64
POS5/0 4002::1/64
POS5/0 3002::2/64
POS5/1 2002::2/64
POS5/2 1003::2/64
POS5/3 4002::2/64
Figure
1273
Receiver
Host A
Host B
Receiver
Host C
Host D
367.