Creating An Msdp Peer Connection; Configuring A Static Rpf Peer - 3Com MSR 50 Series Configuration Manual

Creating an MSDP Peer
Connection
n
Configuring a Static RPF
Peer
n
To do...
Create a VPN instance and
enter VPN instance view
Configure a
route-distinguisher
(RD) for the VPN instance
Enable IP multicast routing
Enable MSDP and enter VPN
instance MSDP view
An MSDP peering relationship is identified by an address pair, namely the address
of the local MSDP peer and that of the remote MSDP peer. An MSDP peer
connection must be created on both devices that are a pair of MSDP peers.
Follow these steps to create an MSDP peer connection:
To do...
Enter system view
Enter public instance MSDP
view or VPN instance MSDP
view
Create an MSDP peer
connection
If an interface of the router is shared by an MSDP peer and a BGP peer at the same
time, we recommend that you configuration the same IP address for the MSDP
peer and BGP peer.
Configuring static RPF peers avoids RPF check of SA messages.
Follow these steps to configure a static RPF peer:
To do...
Enter system view
Enter public instance MSDP
view or VPN instance MSDP
view
Configure a static RPF peer
If only one MSDP peer is configured on a router, this MSDP will be registered as a
static RPF peer.
Configuring Basic Functions of MSDP
Use the command...
ip vpn-instance
vpn-instance-name
route-distinguisher
route-distinguisher
multicast routing-enable
msdp [ vpn-instance
vpn-instance-name ]
Use the command...
system-view
msdp [ vpn-instance
vpn-instance-name ]
peer peer-address
connect-interface
interface-type
interface-number
Use the command...
system-view
msdp [ vpn-instance
vpn-instance-name ]
static-rpf-peer peer-address
[ rp-policy ip-prefix-name ]
1139
Description
-
Required
No RD is configured by
default.
Required
Disabled by default
Required
Disabled by default
Remarks
-
-
Required
No MSDP peer connection
created by default
Remarks
-
-
Required
No static RPF peer configured
by default