Displaying And Maintaining Static Routes; Configuration Example - 3Com MSR 50 Series Configuration Manual

1010 C 61: S
HAPTER TATIC
Displaying and
Maintaining Static
Routes
Configuration
Example
R C
OUTING ONFIGURATION
Network requirements
To detect the reachability of a static route's nexthop through a Track entry, you
need to create a Track first. For detailed Track configuration procedure, refer to
"Track Configuration" on page
Configuration procedure
Follow these steps to detect the reachability of a static route's nexthop through
Track:
To do...
Enter system view
Associate the static
route with a track
entry
n
To configure this feature for an existing static route, simply associate the static
■
route with a track entry. For a non-existent static route, configure it and
associate it with a Track entry.
If the track module uses NQA to detect the reachability of the private network
■
static route's nexthop, the VPN instance number of the static route's nexthop
must be identical to that configured in the NQA test group.
If a static route needs route recursion, the associated track entry must monitor
■
the nexthop of the recursive route instead of that of the static route;
otherwise, a valid route may be mistakenly considered invalid
To do...
View the current
configuration information
View the brief information of
the IP routing table
View the detailed information
of the IP routing table
View information of static
routes
Delete all the static routes
Network requirements
The routers' interfaces and the hosts' IP addresses and masks are shown in the
following figure. Static routes are required for interconnections between any two
hosts.
2207.
Use the command...
system-view
ip route-static dest-address { mask |
mask-length } { gateway-address |
vpn-instance d-vpn-instance-name
gateway-address } track track-entry-number
ip route-static vpn-instance
s-vpn-instance-name&<1-6> dest-address
{ mask | mask-length } { gateway-address
track track-entry-number [ public ] |
vpn-instance d-vpn-instance-name
gateway-address track track-entry-number }
Use the command...
display current-configuration
display ip routing-table
display ip routing-table verbose
display ip routing-table protocol
static [ inactive | verbose ]
delete [ vpn-instance
vpn-instance-name ] static-routes all
Remarks
-
Required
Not configured by
default
Remarks
Available in any
view
Available In system
view