Configuring The Ripng Priority; Configuring Ripng Route Redistribution; Optimizing The Ripng Network - 3Com MSR 50 Series Configuration Manual

1074 C 65: IP 6 RIP
HAPTER V
Configuring the RIPng
Priority
Configuring RIPng Route
Redistribution
Optimizing the RIPng
Network
C
NG ONFIGURATION
To do...
Configure a filter policy
to filter incoming routes
Configure a filter policy
to filter outgoing routes
Any routing protocol has its own protocol priority used for optimal route selection.
You can set a priority for RIPng manually. The smaller the value is, the higher the
priority is.
Follow these steps to configure a RIPng priority:
To do...
Enter system view
Enter RIPng view
Configure a RIPng
priority
Follow these steps to configure RIPng route redistribution:
To do...
Enter system view
Enter RIPng view
Configure a default routing
metric for redistributed routes
Redistribute routes from
another routing protocol
This section describes how to adjust and optimize the performance of the RIPng
network as well as applications under special network environments. Before
adjusting and optimizing the RIPng network, complete the following tasks:
Configure a network layer address for each interface
■
Configure the basic RIPng functions
■
This section covers the following topics:
Configuring RIPng Timers
■
Configuring the Split Horizon and Poison Reverse
■
Configuring Zero Field Check
■
Use the command...
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
import
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
export [ protocol [ process-id ] ]
Use the command...
system-view
ripng [ process-id ]
preference [ route-policy
route-policy-name ] preference
Use the command...
system-view
ripng [ process-id ]
default cost cost
import-route protocol
[ process-id ] [ allow-ibgp ]
[ cost cost | route-policy
route-policy-name ] *
Remarks
Required
By default, RIPng does not
filter incoming routing
information.
Required
By default, RIPng does not
filter outgoing routing
information.
Remarks
-
-
Optional
By default, the RIPng priority
is 100.
Remarks
--
--
Optional
By default, the default metric
of redistribute routes is 0.
Required
By default, RIPng does not
redistribute any other
protocol route.