3Com MSR 50 Series Configuration Manual page 1004

1004 C 60: R
HAPTER OUTING
P C
OLICY ONFIGURATION
[RouterA] ipv6 route-static 20:: 32 serial 2/1
[RouterA] ipv6 route-static 30:: 32 serial 2/1
[RouterA] ipv6 route-static 40:: 32 serial 2/1
# Configure a routing policy.
[RouterA] ip ipv6-prefix a index 10 permit 30:: 32
[RouterA] route-policy static2ripng deny node 0
[RouterA-route-policy] if-match ipv6 address prefix-list a
[RouterA-route-policy] quit
[RouterA] route-policy static2ripng permit node 10
[RouterA-route-policy] quit
# Enable RIPng and apply routing policy static3ripng to filter redistributed static
routes on Router A.
[RouterA] ripng
[RouterA-ripng-1] import-route static route-policy static2ripng
2 Configure Router B.
# Configure the IPv6 address for Serial 2/0 and enable PPP.
<RouterB> system-view
[RouterB] ipv6
[RouterB] interface serial 2/0
[RouterB-Serial2/0] ipv6 address 10::2 32
[RouterB-Serial2/0] link-protocol ppp
# Enable RIPng for interface Serial 2/0.
[RouterB-Serial2/0] ripng 1 enable
[RouterB-Serial2/0] quit
# Enable RIPng.
[RouterB] ripng
# Display RIPng routing table information.
[RouterB-ripng-1] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::7D58:0:CA03:1
Dest 10::/32,
via FE80::7D58:0:CA03:1, cost
Dest 20::/32,
via FE80::7D58:0:CA03:1, cost
Dest 40::/32,
via FE80::7D58:0:CA03:1, cost
on Serial2/0
1, tag 0, A, 18 Sec
1, tag 0, A, 8 Sec
1, tag 0, A, 3 Sec