Configuring An Ipv6 Static Route; Displaying And Maintaining Ipv6 Static Routes; Ipv6 Static Routing Configuration Example - 3Com MSR 50 Series Configuration Manual

3com msr 30-16: software guide
Hide thumbs Also See for MSR 50 Series:
Table of Contents

Advertisement

1082
C
66: IP
6 S
HAPTER
V
Configuring an IPv6
Static Route
Displaying and
Maintaining IPv6
Static Routes
IPv6 Static Routing
Configuration
Example
R
C
TATIC
OUTING
ONFIGURATION
To do...
Enter system view
Configure an IPv6 static route
with the output interface
being a broadcast or NBMA
interface
Configure an IPv6 static route
with the output interface
being a point-to-point
interface
n
While configuring a static route, you can configure either the output interface or
the next-hop address depending on the situations
If the output interface is a broadcast interface, such as an Ethernet interface, a
VLAN interface, or an NBMA interface (such as an X.25 interface or frame relay
interface), then the next hop address must be specified.
If the output interface is a point-to-point interface (such as a serial port), you
can specify either the output interface or the next hop address, but not both.
To do...
Display IPv6 static route
information
Remove all IPv6 static
routes
n
Using the undo ipv6 route-static command can delete a single IPv6 static route,
while using the delete ipv6 static-routes all command deletes all IPv6 static
routes including the default route.
Network requirements
With IPv6 static routes configured, all hosts and routers can interact with each
other. The serial ports of the routers use the IPv6 local link addresses.
Use the commands...
System-view
ipv6 route-static ipv6-address
prefix-length [ interface-type
interface-number ] nexthop-address
[ preference preference-value ]
ipv6 route-static ipv6-address
prefix-length { interface-type
interface-number | nexthop-address }
[ preference preference-value ]
Use the command...
display ipv6 routing-table protocol static
[ inactive | verbose ]
delete ipv6 static-routes all
Remarks
-
Required
The default
preference of IPv6
static routes is 60.
Remarks
Available in any
view
Available in system
view

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents