Configuring Link Costs For Ospfv3 Interfaces; Configuring The Maximum Number Of Ospfv3 Load-Balanced Routes; Configuring A Priority For Ospfv3 - 3Com MSR 50 Series Configuration Manual

n
Configuring Link Costs
for OSPFv3 Interfaces
Configuring the
Maximum Number of
OSPFv3 Load-balanced
Routes
Configuring a Priority
for OSPFv3
To configure inbound route filtering, use the following commands:
To do...
Enter system view
Enter OSPFv3 view
Configure inbound route
filtering
Use of the filter-policy import command can only filter routes computed by
OSPFv3. Only routes not filtered can be added into the local routing table.
You can configure OSPFv3 link costs for interfaces to adjust routing calculation.
To configure the link cost for an OSPFv3 interface, use the following commands:
To do...
Enter system view
Enter interface view
Configure the cost for the
interface
If multiple routes to a destination are available, using load balancing to send IPv6
packets on these routes in turn can improve link utility. To configure the maximum
number of load-balanced routes, use the following commands:
To do...
Enter system view
Enter OSPFv3 view
Specify the maximum number of
load-balanced routes
A router may run multiple routing protocols. The system assigns a priority for each
protocol. When these routing protocols find the same route, the route found by
the protocol with the highest priority is selected.
To configure a priority for OSPFv3, use the following commands:
To do...
Enter system view
Enter OSPFv3 view
Configure a priority for
OSPFv3
Configuring OSPFv3 Routing Information Management
Use the command...
system-view
ospfv3 [ process-id ]
filter-policy { acl-number |
ipv6-prefix
ipv6-prefix-name } import
Use the command...
system-view
interface interface-type
interface-number
ospfv3 cost value [ instance
instance-id ]
Use the command...
system-view
ospfv3 [ process-id ]
maximum load-balancing maximum
Use the command...
system-view
ospfv3 [ process-id |
preference [ ase ]
[ route-policy
route-policy-name ] preference
Remarks
-
-
Required
Not configured by default
Remarks
-
-
Optional
By default, OSPFv3 computes
an interface's cost according
to the bandwidth on it.
Remarks
-
-
Optional
Remarks
-
-
Optional
By default, the priority of OSPFv3
interval routes is 10, and priority
of OSPFv3 external routes is 150.
1055