Rip Features Supported; Protocols And Standards; Configuring Rip Basic Functions; Configuration Prerequisites - 3Com MSR 50 Series Configuration Manual

976 C 59: RIP C
HAPTER

RIP Features Supported

Protocols and Standards

Configuring RIP Basic
Functions
Configuration
Prerequisites

Configuration Procedure

ONFIGURATION
receiving no Update Acknowledge after the upper limit for sending Update
Responses is reached, the router considers the neighbor unreachable.
The current implementation supports the following RIP features.
RIP-1 and RIP-2
■
RIP Multi-instance. This means that RIP can serve as an internal VPN routing
■
protocol, running between CE and PE on the BGP/MPLS VPN network. For
related information, refer to
Basics Configuration" on page
TRIP
■
RFC 1058: Routing Information Protocol
■
RFC 1723: RIP Version 2 - Carrying Additional Information
■
RFC 1721: RIP Version 2 Protocol Analysis
■
RFC 1722: RIP Version 2 Protocol Applicability Statement
■
RFC 1724: RIP Version 2 MIB Extension
■
RFC 2082: RIP-2 MD5 Authentication
■
RFC 2091: Triggered Extensions to RIP to Support Demand Circuits
■
Before configuring RIP features, finish the following tasks.
Configure the link layer protocol.
■
Configure IP address on each interface, and make sure all adjacent routers are
■
reachable with each other.
Enable RIP and specify networks to run RIP
Follow these steps to enable RIP and specify networks to run RIP
To do...
Enter system view
Enable a RIP process and enter
RIP view
Enable RIP on the network of
an interface
n
If you make some RIP configurations in interface view before enabling RIP,
■
those configurations will take effect after RIP is enabled.
RIP runs only on the interfaces residing on the specified networks. Therefore,
■
you need specify the network after enabling RIP to validate RIP on a specific
interface.
You can enable RIP on all interfaces using the command network 0.0.0.0.
■
"BGP Configuration" on page 825
1311.
Use the command...
system-view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
network network-address
and "MPLS
Remarks
--
Required
Disabled by default
Required
Disabled by default