Configuring Zero Field Check; Configuring The Maximum Number Of Load Balanced Routes; Displaying And Maintaining Ripng - 3Com MSR 50 Series Configuration Manual

1076 C 65: IP 6 RIP
HAPTER V
Configuring Zero Field
Check
Configuring the
Maximum Number of
Load Balanced Routes
Displaying and
Maintaining RIPng
C
NG ONFIGURATION
information, refer to
LAPB Configuration" on page
Configuring the poison reverse function
The poison reverse function enables a route learned from an interface to be
advertised via the interface. However, the metric of the route is set to 16. That is to
say, the route is unreachable.
Follow these steps to configure poison reverse:
To do...
Enter system view
Enter interface view
Enable the poison reverse
function
Some fields in RIPng packet headers must be zero. These fields are called zero
fields. You can enable the zero field check on RIPng packets. If any such field
contains a non-zero value, the entire RIPng packet will be discarded. If you are sure
that all packets are trusty, you can disable the zero field check to save the CPU
processing time.
Follow these steps to configure RIPng zero field check:
To do...
Enter system view
Enter RIPng view
Enable the zero field check
Follow these steps to configure the maximum number of RIPng load balanced
routes with equal cost:
To do...
Enter system view
Enter RIPng view
Configure the maximum number of
load balanced routes
To do...
Display configuration
information of a RIPng
process
Display routes in the RIPng
database
"Frame Relay Configuration" on page 235
283.
Use the command...
system-view
interface interface-type
interface-number
ripng poison-reverse
Use the command...
system-view
ripng [ process-id ]
checkzero
Use the command...
system-view
ripng [ process-id ]
maximum load-balancing number Optional
Use the command...
display ripng [ process-id ]
display ripng process-id
database
and "X.25 and
Remarks
--
--
Required
Disabled by default
Remarks
--
--
Optional
Enabled by default
Remarks
--
--
Remarks
Available in any view
Available in any view