3Com MSR 50 Series Configuration Manual page 1083

Network diagram
Figure 315 Network diagram for static route configuration
Eth1/0
1::1/64
Host A
1 ::2/64
Configuration procedure
1 Configure IPv6 addresses for all interfaces (Omitted).
2 Configure IPv6 static routes.
# Configure the default IPv6 route on Router A.
<RouterA> system-view
[RouterA] ipv6 route-static :: 0 serial 2/0
# Configure two IPv6 static routes on RouterB.
<RouterB> system-view
[RouterB] ipv6 route-static 1:: 64 serial 2/0
[RouterB] ipv6 route-static 3:: 64 serial 2/1
# Configure the default IPv6 route on Router C.
<RouterC> system-view
[RouterC] ipv6 route-static :: 0 serial 2/0
3 Configure the IPv6 addresses of hosts and gateways.
Configure the IPv6 addresses of all the hosts based upon the network diagram,
configure the default gateway of Host A as 1::1, that of Host B as 2::1, and that of
Host C as 3::1.
4 Display configuration information
# Display the IPv6 routing table on RouterA.
[RouterA] display ipv6 routing-table
Routing Table :
Destinations : 5
Destination : ::
NextHop : FE80::510A:0:8D7:1
Interface : S2/0
Destination : ::1
IPv6 Static Routing Configuration Example
Host B
Eth1 /0
2::1/64
S2/0 S2/1
Router B
S2/0
Router A
Routes : 5
2::2/64
S2/0
Eth1/0
3::1/64
Router C
Host C
Protocol
Preference
Cost : 0
Protocol
1083
3::2/64
: Static
: 60
: Direct