Configuring Join/Prune Message Limits - 3Com MSR 50 Series Configuration Manual

1262 C 74: IP 6 PIM C
HAPTER V
n
Configuring Join/Prune
Message Limits
ONFIGURATION
To do...
Configure the join/prune
interval
Configure the join/prune
timeout time
Configure the IPv6 multicast
source lifetime
Configuring IPv6 PIM common timers on an interface
Follow these steps to configure IPv6 PIM common timers on an interface:
To do...
Enter system view
Enter interface view
Configure the hello interval
Configure the maximum delay
between hello messages
Configure assert timeout time pim ipv6 holdtime assert
Configure the join/prune
interval
Configure the join/prune
timeout time
If there are no special networking requirements, we recommend that you use the
default settings.
A larger join/prune message size will result in loss of a larger amount of
information when a message is lost; with a reduced join/message size, the loss of a
single message will bring relatively minor impact.
By controlling the maximum number of (S, G) entries in a join/prune message, you
can effectively reduce the number of (S, G) entries sent per unit of time.
Follow these steps to configure join/prune message limits:
To do...
Enter system view
Enter IPv6 PIM view
Configure the maximum size of a
join/prune message
Configure the maximum number
of (S, G) entries in a join/prune
message
Use the command...
timer join-prune interval
holdtime join-prune interval Optional
source-lifetime interval
Use the command...
system-view
interface interface-type
interface-number
pim ipv6 timer hello interval Optional
pim ipv6
triggered-hello-delay
interval
interval
pim ipv6 timer join-prune
interval
pim ipv6 holdtime
join-prune interval
Use the command...
system-view
pim ipv6
jp-pkt-size packet-size
jp-queue-size queue-size
Remarks
Optional
60 seconds by default
210 seconds by default
Optional
210 seconds by default
Remarks
-
-
30 seconds by default
Optional
5 seconds by default
Optional
180 seconds by default
Optional
60 seconds by default
Optional
210 seconds by default
Remarks
-
-
Optional
8,100 bytes by default
Optional
1,020 by default