[:Source[<N>]]:Apply; [:Source[<N>]]:Apply:noise; [:Source[<N>]]:Apply:pulse; [:Source[<N>]]:Apply:ramp - Rigol DS1000Z Series Programming Manual

Chapter 2 Command System
[:SOURce[<n>]]:APPLy?
Syntax
[:SOURce[<n>]]:APPLy?
Description Query the output configurations of the specified source channel.
Parameter
Name
[<n>]
Return The query returns the output configurations in "<waveform
Format
name>,<frequency>,<amplitude>,<offset>,<start phase>" format. If the
corresponding parameter does not exist, it will be replaced by "DEF".
Example
:APPLy?
[:SOURce[<n>]]:APPLy:NOISe
[:SOURce[<n>]]:APPLy:PULSe
[:SOURce[<n>]]:APPLy:RAMP
[:SOURce[<n>]]:APPLy:SINusoid
[:SOURce[<n>]]:APPLy:SQUare
[:SOURce[<n>]]:APPLy:USER
Syntax [:SOURce[<n>]]:APPLy:NOISe [<amp>[,<offset>]]
[:SOURce[<n>]]:APPLy:PULSe [<freq>[,<amp>[,<offset>[,<phase>]]]]
[:SOURce[<n>]]:APPLy:RAMP [<freq>[,<amp>[,<offset>[,<phase>]]]]
[:SOURce[<n>]]:APPLy:SINusoid [<freq>[,<amp>[,<offset>[,<phase>]]]]
[:SOURce[<n>]]:APPLy:SQUare [<freq>[,<amp>[,<offset>[,<phase>]]]]
[:SOURce[<n>]]:APPLy:USER [<freq>[,<amp>[,<offset>[,<phase>]]]]
Description Configure the specified source channel to output the signal with the specified waveform
and parameters.
Parameter Name
[<n>]
<freq>
<amp>
<offset>
<phase>
DS1000Z Programming Guide
Type Range
Discrete {1|2}
/*The query returns SIN,1000.000000,1.000000,0.000000,0.000000*/
Type Range
Discrete {1|2}
Sine: 0.1Hz to 25MHz
Square: 0.1Hz to 15MHz
Real Pulse: 0.1Hz to 1MHz
Ramp: 0.1Hz to 100kHz
Arbitrary waveform: 0.1Hz to 10MHz
Related to the output impedance:
Real HighZ: 20mVpp to 5Vpp
50Ω: 10mVpp to 2.5Vpp
Related to the output impedance and
amplitude:
Real
HighZ: ±(2.5V-current amplitude/2)
50Ω: ±(1.25V-current amplitude/2)
Real 0° to 360°
Default
If omitted, the operation is performed on
source 1 by default
RIGOL
Default
If omitted, the
operation is
performed on source
1 by default
100kHz
1Vpp
0mV
0°
2-75