Table 135: Wbm "Configuration Of Mac Address Filter" Page - "Mac Address Filter State Bridge <N>" Group; Table 136: Wbm "Configuration Of Mac Address Filter" Page - "Mac Address - WAGO I/O System 750 Manual

WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR
"MAC address filter state Bridge <n>" Group
A separate group is displayed for each configured bridge.
Table 135: WBM "Configuration of MAC Address Filter" Page – "MAC address filter state Bridge <n>"
Group
Parameter
Filter enabled
Click the [Submit] button to apply the change. The change takes effect
immediately.
"MAC address filter whitelist" Group
Each list entry has its own area in the display.
Table 136: WBM "Configuration of MAC Address Filter" Page – "MAC address filter whitelist" Group
Parameters
Description
MAC address
MAC mask
Filter enabled
Add filter to whitelist
MAC address
MAC mask
Filter enabled
Click the [Submit] button to apply the change. The change takes effect
immediately.
Click the appropriate [Delete] button to remove an existing list entry. The change
takes effect immediately.
Click [Add] to accept a new list entry. You can enter 10 filters. The change takes
effect immediately.
Explanation
Enable or disable here the MAC address filter for the
specific bridge.
This setting is independent of the "Firewall enabled
entirely" setting on the General Firewall
Configuration page.
Explanation
Description of the devices or areas that can be
enabled by activating the filter when the firewall is
generally enabled.
The description is only visible for entries initially
available in the factory default settings.
Displays the MAC address of the relevant list entry.
This displays the MAC mask of the relevant list
entry.
Enable or disable the filter for the relevant list entry.
Create a new list entry.
Enter here the MAC address for a new list entry.
You can enter 10 filters.
Enter the MAC mask for the new list entry.
Enable or disable the filter for the new list entry.
Version 1.7.0, valid from FW Version 04.01.10(23)
Appendix 231
Manual