Operating Elements; Figure 8: Coding Switch For The Profisafe Address (Set To 1018) - WAGO 8FDI 24V PROFIsafe 750-662/000-004 Manual

Table of Contents

Device Description

3.4

Operating Elements

You can use the coding switch located on the side of the F I/O module to set the

PROFIsafe address.

Coding switch is inaccessible when the I/O module is plugged in!

To set the PROFIsafe address on the coding switch, you must power down the

fieldbus node and then unplug the I/O module from the fieldbus node.

Set the PROFIsafe address as described in the section "Setting the PROFIsafe

Address".

Manual

Version 1.0.0, valid from HW/SW Version 01/01

WAGO I/O System

750-662/000-004 8FDI 24V PROFIsafe

Table of Contents

Table of Contents