Functions
4.4.2.8 Current Measurement Function Block
The current is measured via two measurement amplifiers per H-bridge, on the left and
right half bridge.
The parameters are fixed and cannot be changed.
4.4.2.9 Nominal Current Function Block
This function block calculates the setpoint in mA from the setpoint in %. The PA_NOMI-
NAL_CURRENT parameter must be set to the nominal current of the coil specified by the
manufacturer of the connected proportional valve actuator. The parameter value corre-
sponds to a setpoint of 100 %.
The setpoint is specified at a resolution of 0.01 % of the nominal current setting. The
value range extends from −100 % to +100 %. Unless otherwise specified in the parame-
terization, the unit in which the actual value is displayed is mA. The resolution is 0.1 mA
per LSB. The following table illustrates this:
Variable
PA_NOMINAL_CURR
Process value (Vx_SETPOINT)
Current value (Vx_ACTUAL)
The nominal current is set with the PA_NOMINAL_CURRENT parameter
Tables 152 and 153
52
Product manual | Version: 1.1.0
Proportional Valve Module 2-3-4
Table 24: Nominal Current Function Block – Example with Process Value of 10 %
Value
2000
1000
200
[} 35].
750-1632/000-100
Figure 31: Current Measurement Function Block
Figure 32: Nominal Current Function Block
Unit
mA
0.01 %
mA
in8 Parameter