•
Resume Build
door, or top hood is open, or if vacuum is not present, the screen will display
Can't Resume (Help)
•
Modeler Status
•
Operator Control
(including load/unload and canister removal/installation), move the head, or
move the Z stage.
•
Abort Job
•
Auto-Cool
only. See
After a Job Build
Warning: Wear proper safety equipment when handling items
inside the oven. Surfaces in the build chamber can be very hot.
1.
The system performs the following actions:
A.
B.
C.
D.
2.
Remove the part from the system.
Note: If Auto Cool-Down is active, allow the oven to cool to
the standby temperature before removing the part.
A.
B.
Caution: Do not attempt to remove a part from the build sheet
while the build sheet is on the platen. Damage to the platen or
the platen level may occur.
C.
Caution: Use extreme care when cleaning the platen. If using a
brush, brush away from the vacuum port in the center of the
platform. If debris falls into the vacuum port, it can cause a
loss of vacuum, resulting in poor adhesion of the build sheet
during building.
- the system resumes building the part. If the oven door, top
.
- View the Job Status and Canister Status.
- Unlock the door/hood, clean tips, change materials
- Aborts the current job.
- The auto-cool down setting can be changed for the current job
"Oven Temperature Control" on page 4-35
The Z stage is lowered and the head is parked.
If Auto Cool-Down is ON the oven automatically cools to the standby
temperature. See
"Oven Temperature Control" on page 4-35
information.
The screen displays
Done
If the build has been terminated abnormally, press HELP to list the reason
for the termination.
Open the oven door.
Push up on the edge of the build sheet to release the vacuum grip.
Remove the build sheet from the platen.
, and prompts you to remove the part.
4-10
for more information.
for more