After A Job Build - Stratasys FORTUS 360mc Manual

FORTUS 360mc/400mc and FDM 360mc/400mc User Guide

After a Job Build

Warning: Wear proper safety equipment when handling items
inside the oven. Surfaces in the build chamber can be very hot.
1.
The system performs the following actions:
A.
The Z stage is lowered and the head is parked.
B.
If Auto Cool-Down is ON the oven automatically cools to the
standby temperature. See
35 for more information.
C.
The screen displays
D.
If the build has been terminated abnormally, press HELP to list the
reason for the termination.
2.
Remove the part from the system.
Note: If Auto Cool-Down is active, allow the oven to cool to
the standby temperature before removing the part.
A.
Open the oven door.
B.
Push up on the edge of the build sheet to release the vacuum grip.
Caution: Do not attempt to remove a part from the build sheet
while the build sheet is on the platen. Damage to the platen or
the platen level may occur.
C.
Remove the build sheet from the platen.
Caution: Use extreme care when cleaning the platen. If using
a brush, brush away from the vacuum port in the center of the
platform. If debris falls into the vacuum port, it can cause a
loss of vacuum, resulting in poor adhesion of the build sheet
during building.
D.
Remove debris that may have fallen onto the platen - use a vacuum
or a soft brush.
3.
Carefully peel the part from the build sheet.
• If the part does not peel easily, use the metal scraper included in
your Startup Kit to carefully pry the part from the sheet.
• The build sheet is intended for one-time use. Do not turn a build
sheet over and place it on the platen. Material residue on the sheet
can adhere to the platen or interfere with the build sheet vacuum.
4.
Press ESCAPE to return to the Main Menu.
5.
Remove supports from the completed part.
"Oven Temperature Control" on page 4-
, and prompts you to remove the part.
Done
4-11