After A Job Build - Stratasys Fortus 360mc User Manual

3. From Pause mode, you can make the following selections:
•
Resume Build
or if vacuum is not present, the screen will display
•
Modeler Status
•
Operator Control
canister removal/installation), move the head, or move the Z stage.
•
Abort Job
•
Auto-Cool
Temperature Control" on page 58

AFTER A JOB BUILD

Warning: Wear proper safety equipment when handling items inside the oven.
Surfaces in the build chamber can be very hot.
After the build is complete the system performs the following actions:
• The Z stage is lowered and the head is parked.
• If Auto Cool-Down is ON the oven automatically cools to the standby temperature. See
Temperature Control" on page 58
The screen displays
•
If the build has been terminated abnormally, press HELP to list the reason for the termination.
•
To remove the completed part from the system:
Note: If Auto Cool-Down is active, allow the oven to cool to the standby
temperature before removing the part.
1. Open the oven door.
2. Push up on the edge of the build sheet to release the vacuum grip.
Caution: Do not attempt to remove a part from the build sheet while the build
sheet is on the platen. Damage to the platen or the platen level may occur.
3. Remove the build sheet from the platen.
Caution: Use extreme care when cleaning the platen. If using a brush, brush
away from the vacuum port in the center of the platform. If debris falls into the
vacuum port, it can cause a loss of vacuum, resulting in poor adhesion of the
build sheet during building.
4. Remove debris that may have fallen onto the platen - use a vacuum or a soft brush.
5. Carefully peel the part from the build sheet.
If the part does not peel easily, use the metal scraper included in your Startup Kit to carefully pry the
•
part from the sheet.
• The build sheet is intended for one-time use. Do not turn a build sheet over and place it on the
platen. Material residue on the sheet can adhere to the platen or interfere with the build sheet
vacuum.
6. Press ESCAPE to return to the Main Menu.
7. Remove supports from the completed part.
- the system resumes building the part. If the oven door, top door, or top hood is open,
- View the Job Status and Canister Status.
- Unlock the door/hood, clean tips, change materials (including load/unload and
- Aborts the current job.
- The auto-cool down setting can be changed for the current job only. See
, and prompts you to remove the part.
Done
Can't Resume (Help)
for more information.
for more information.
37
.
"Oven
"Oven