Set Igmp Mrouter Interface; Igmp Snooping Show Commands; Show Igmpsnooping - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
16.1.7.1 no set igmp mrouter
This command disables multicast router mode for a particular VLAN ID (<
Format
Mode

16.1.8 set igmp mrouter interface

This command configures the interface as a multicast router interface. When configured as
a multicast router interface, the interface is treated as a multicast router interface in all
VLANs.
Default
Format
Mode
16.1.8.1 no set igmp mrouter interface
This command disables the status of the interface as a statically configured multicast
router interface.
Format
Mode

16.2 IGMP Snooping Show Commands

This section describes the commands you use to view IGMP snooping status and
information.

16.2.1 show igmpsnooping

This command displays IGMP Snooping information. Configured information is
displayed whether or not IGMP Snooping is enabled.
Format
Mode
When the optional arguments
displays the following information:
Admin Mode
16-6
no set igmp mrouter <vlanId>
Interface Config
disabled
set igmp mrouter interface
Interface Config
no set igmp mrouter interface
Interface Config
show igmpsnooping [<slot/port> | <vlanId>]
Privileged EXEC
or
<slot/port> <vlanId>
This indicates whether or not IGMP Snooping is active on the
switch.
v1.0, December 2005
vlanId
are not used, the command
IGMP Snooping Commands
>).