Neighbor Msgsendlimit; Neighbor Next-Hop-Self - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
14.8.48.1 no neighbor connretry
This command specifies the default connection retry interval for a peer.
Format
Mode

14.8.49 neighbor msgsendlimit

This command configures the maximum number of messages in a peer transmission
queue. The range for
the neighboring BGP4 speaker's IP address.
Default
Format
Mode
14.8.49.1 no neighbor msgsendlimit
This command configures the default number of messages in the peer transmission queue
Format
Mode

14.8.50 neighbor next-hop-self

This command enables the peer as the next hop for the locally originated paths. The
possible values for this field are
peer must be reset before the changes take effect.
Default
Format
Mode
14.8.50.1 no neighbor next-hop-self
This command disables the peer as the next hop for the locally originated paths. After
executing this command, the BGP peer must be reset before the changes take effect.
Format
Mode
14-86
no neighbor <peeripaddr> connretry
Router BGP Config
is 1 to 100. The <
<sendlimit>
100
neighbor <peeripaddr> msgsendlimit <sendlimit>
Router BGP Config
no neighbor <peeripaddr> msgsendlimit <sendlimit>
Router BGP Config
and
enable disable.
disabled
neighbor <peeripaddr> next-hop-self
Router BGP Config
no neighbor <peeripaddr> next-hop-self
Router BGP Config
v1.0, December 2005
parameter specifies
peeripaddr>
After executing this command, the BGP
Routing Commands