Ip Ospf Cost; Ip Ospf Dead-Interval - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Format
Mode
14.6.28.1 no ip ospf authentication
This command sets the default OSPF Authentication Type for the specified interface.
Format
Mode

14.6.29 ip ospf cost

This command configures the cost on an OSPF interface. The <
range of 1 to 65535.
Default
Format
Mode
14.6.29.1 no ip ospf cost
This command configures the default cost on an OSPF interface.
Format
Mode

14.6.30 ip ospf dead-interval

This command sets the OSPF dead interval for the specified interface. The interval is the
length of time in seconds that a router's Hello packets have not been seen before its
neighbor routers declare that the router is down. The interval must be the same for all
routers attached to a common network. This value should be some multiple of the Hello
Interval (i.e. 4).
Default
Format
Mode
Routing Commands
ip ospf authentication {none | {simple <key>} |
{encrypt <key> <keyid>}}
Interface Config
no ip ospf authentication
Interface Config
10
ip ospf cost <1-65535>
Interface Config
no ip ospf cost
Interface Config
40
ip ospf dead-interval <1-2147483647>
Interface Config
v1.0, December 2005
> parameter has a
cost
14-41