No Ip Mcast Mroute; Show Ip Mcast - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
If a debug command is already in execution, a message is displayed and the new request
fails.
Note: The group and destination IP addresses can be entered in any order.
Default
Format
Mode

15.1.9 no ip mcast mroute

This command is used to clear entries in the mroute table. The all parameters is used to
clear all entries.
The source parameter is used to clear the routes in the mroute table entries containing the
specified <
sourceipaddr>
address is the source IP address of the multicast packet. The group address is the Group
Destination IP address of the multicast packet.
The group parameter is used to clear the routes in the mroute table entries containing the
specified <
groupipaddr>
multicast packet.
Default
Format
Mode

15.1.10 show ip mcast

This command displays the system-wide multicast information.
Format
Modes
Admin Mode
Protocol State
15-6
none
mtrace <sourceipaddr> [<group/destination>]
[<group/destination >]
Privileged EXEC
or
<sourceipaddr> [groupipaddr]
. The group address is the Group Destination IP address of the
none
no ip mcast mroute {group <groupipaddr> | source
<sourceipaddr> [<groupipaddr>] | all}
Global Config
show ip mcast
Privileged EXEC
User EXEC
The administrative status of multicast.
The current state of the multicast protocol. Possible values
are Operational or Non-Operational.
v1.0, December 2005
pair. The source
IP Multicast Commands