Show Poe - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
17.1.5.3 Limit
The LIMIT field is the preset limit defined by the "config poe port limit" command. This
value is stated in watts.
17.1.5.4 Status
The Status field reports the state of power supplied to the associated port. Possible values
are:
• Disabled—the POE function is disabled on this port
• Searching—the port is detecting POE device
• Delivering Power—the port is providing power to POE device
• Fault—the POE device is not IEEE compliance, no power is provided
• Test—the port is in testing state
• Other Fault—the port has experience problems other than compliance issue
When a port begins to deliver power, there will be a trap indicating so. When a port stops
delivering power, there will be a trap indicating so.

17.1.6 show poe

This command displays the total power available and the total power consumed in the
system.
Format
Mode
Power Over Ethernet Commands
show poe
Privilege
v1.0, December 2005
17-5