Ip Multicast Staticroute; Ip Multicast Ttl-Threshold - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
15.1.2.1 no ip mcast boundary
This command deletes an administrative scope multicast boundary specified by
<
groupipaddr
applicable. <
groupipaddr
Format
Mode

15.1.3 ip multicast staticroute

This command creates a static route which is used to perform RPF checking in multicast
packet forwarding. The combination of the <
specify the network IP address of the multicast packet source. The <
IP address of the next hop toward the source. The <
for comparison with other routes to the source network and is a value in the range of 0 and
255. The
current
matching this multicast static route entry.
Default
Format
Mode
15.1.3.1 no ip multicast staticroute
This command add deletes a static route in the static mcast table. The <
the IP address of the multicast packet source.
Format
Mode

15.1.4 ip multicast ttl-threshold

This command applies the given <
<
ttlthreshold>
which are to be forwarded from the interface
from 0 to 255.
Default
Format
Mode
IP Multicast Commands
> and < > for which this multicast administrative boundary is
mask
> is a group IP address and <
no ip mcast boundary <groupipaddr> <mask>
Interface Config
incoming interface is used for RPF checking for multicast packets
none
ip multicast staticroute <sourceipaddr> <mask>
<rpfipaddr> <metric> <slot/port>
Global Config
no ip multicast staticroute <sourceipaddr>
Global Config
ttlthreshold>
is the TTL threshold which is to be applied to the multicast Data packets
1
ip multicast ttl-threshold <ttlvalue>
Interface Config
v1.0, December 2005
> is a group IP mask.
mask
and the <
sourceipaddr>
is the cost of the route entry
metric>
to a routing interface. The
The value for <
. ttlthreshold>
fields
mask>
is the
groupipaddr>
is
sourceipaddr>
has range
15-3