Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
14.2.6 ip route distance
This command sets the default distance for static routes. Lower route preference values
are preferred when determining the best route. The
commands allow you to optionally set the distance of an individual static route. The
default distance is used when no distance is specified in these commands. Changing the
default distance does not update the distance of existing static routes, even if they were
assigned the original default distance. The new default distance will only be applied to
static routes created after invoking the
Default
Format
Mode
14.2.6.1 no ip route distance
This command sets the default static route preference value in the router. Lower route
preference values are preferred when determining the best route.
Format
Mode
14.2.7 ip forwarding
This command enables forwarding of IP frames.
Default
Format
Mode
14.2.7.1 no ip forwarding
This command disables forwarding of IP frames.
Format
Mode
Routing Commands
ip route distance
1
ip route distance <1-255>
Global Config
no ip route distance
Global Config
enabled
ip forwarding
Global Config
no ip forwarding
Global Config
v1.0, December 2005
and
ip route
ip route default
command.
14-11