Show Ip Ospf Interface - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

14.6.43 show ip ospf interface

This command displays the information for the IFO object or virtual interface tables.
Format
Modes
IP Address
Subnet Mask
OSPF Admin
Mode
OSPF Area ID
Router Priority
Retransmit
Interval
Hello Interval
Dead Interval
LSA Ack Interval
Transit Delay
Interval
Authentication
Type
The information below will only be displayed if OSPF is enabled.
OSPF Interface
Type
14-50
show ip ospf interface <slot/port>
Privileged EXEC
User EXEC
Represents the IP address for the specified interface.
A mask of the network and host portion of the IP address for
the OSPF interface.
States whether OSPF is enabled or disabled on a router inter-
face.
Represents the OSPF Area Id for the specified interface.
A number representing the OSPF Priority for the specified
interface.
A number representing the OSPF Retransmit Interval for the
specified interface.
A number representing the OSPF Hello Interval for the speci-
fied interface.
A number representing the OSPF Dead Interval for the speci-
fied interface.
A number representing the OSPF LSA Acknowledgement
Interval for the specified interface.
A number representing the OSPF Transit Delay for the speci-
fied interface.
The OSPF Authentication Type for the specified interface
are: none, simple, and encrypt.
Broadcast LANs, such as Ethernet and IEEE 802.5, take the
value . The OSPF Interface Type will be 'broadcast'.
broadcast
v1.0, December 2005
Routing Commands