Snmp-Server Enable Traps Bcaststorm; Snmp-Server Enable Traps Linkmode; Snmp-Server Enable Traps Multiusers - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

10.1.10 snmp-server enable traps bcaststorm

This command enables the broadcast storm trap. When enabled, broadcast storm traps are
sent only if the broadcast storm recovery mode setting associated with the port is enabled.
Default
Format
Mode
10.1.10.1 no snmp-server enable traps bcaststorm
This command disables the broadcast storm trap. When enabled, broadcast storm traps are
sent only if the broadcast storm recovery mode setting associated with the port is enabled.
Format
Mode

10.1.11 snmp-server enable traps linkmode

This command enables Link Up/Down traps for the entire switch. When enabled, link
traps are sent only if the Link Trap flag setting associated with the port is enabled.
10.1.18 "snmp trap link-status" on page 10-9
Default
Format
Mode
10.1.11.1 no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
Format
Mode

10.1.12 snmp-server enable traps multiusers

This command enables Multiple User traps. When the traps are enabled, a Multiple User
Trap is sent when a user logs in to the terminal interface (EIA 232 or telnet) and there is an
existing terminal interface session.
Default
Format
Mode
10-6
enabled
snmp-server enable traps bcaststorm
Global Config
no snmp-server enable traps bcaststorm
Global Config
enabled
snmp-server enable traps linkmode
Global Config
no snmp-server enable traps linkmode
Global Config
enabled
snmp-server enable traps multiusers
Global Config
v1.0, December 2005
Section
SNMP Commands