Ip Pimsm Query-Interval; Ip Pimsm Spt-Threshold; Ip Pim-Trapflags - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

15.4.7 ip pimsm query-interval

This command configures the transmission frequency of hello messages in seconds
between PIM enabled neighbors. This field has a range of 10 to 3600 seconds.
Default
Format
Mode
15.4.7.1 no ip pimsm query-interval
This command resets the transmission frequency of hello messages between PIM enabled
neighbors to the default value.
Format
Mode

15.4.8 ip pimsm spt-threshold

This command is used to configure the Threshold rate for the RP router to switch to the
shortest path. The rate is specified in Kilobytes per second. The possible values are 0 to
2000.
Default
Format
Mode
15.4.8.1 no ip pimsm spt-threshold
This command is used to reset the Threshold rate for the RP router to switch to the shortest
path to the default value.
Format
Mode

15.4.9 ip pim-trapflags

This command enables the PIM trap mode for both Sparse Mode (SM) and Dense Mode.
(DM).
Default
Format
Mode
IP Multicast Commands
30
ip pimsm query-interval <10-3600>
Interface Config
no ip pimsm query-interval
Interface Config
50
ip pimsm spt-threshold <0-2000>
Global Config
no ip pimsm spt-threshold
Global Config
disabled
ip pim-trapflags
Global Config
v1.0, December 2005
15-23