Show Ip Igmp Interface Membership - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Query Max
Response Time
Robustness
Startup Query
Interval
Startup Query
Count
Last Member
Query Interval
Last Member
Query Count

15.5.13 show ip igmp interface membership

This command displays the list of interfaces that have registered in the multicast group.
Format
Mode
Interface
Interface IP
State
Group
Compatibility
Mode
IP Multicast Commands
The maximum query response time advertised in IGMPv2
queries on this interface.
The tuning for the expected packet loss on a subnet. If a sub-
net is expected to be have a lot of loss, the Robustness vari-
able may be increased for that interface.
The interval between General Queries sent by a Querier on
startup.
The number of Queries sent out on startup, separated by the
Startup Query Interval.
The Maximum Response Time inserted into Group-Specific
Queries sent in response to Leave Group messages.
The number of Group-Specific Queries sent before the router
assumes that there are no local members.
show ip igmp interface membership <multiipaddr>
[detail]
Privileged EXEC
Valid unit, slot and port number separated by forward slashes.
The IP address of the interface participating in the multicast
group.
The interface that has IGMP in Querier mode or Non-Querier
mode.
The group compatibility mode (v1, v2 or v3) for the specified
group on this interface.
v1.0, December 2005
15-35