Arp; Ip Proxy-Arp - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

14.1.1 arp

This command creates an ARP entry. The value for
device on a subnet attached to an existing routing interface.
address for that device.
The format is 6 two-digit hexadecimal numbers that are separated by colons, for example
00:06:29:32:81:40.
Format
Mode
14.1.1.1 no arp
This command deletes an ARP entry. The value for
interface. The value for
an existing routing interface.
Format
Mode

14.1.2 ip proxy-arp

This command enables proxy ARP on a router interface. Without proxy ARP, a device
only responds to an ARP request if the target IP address is an address configured on the
interface where the ARP request arrived. With proxy ARP, the device may also respond if
the target IP address is reachable. The device only responds if all next hops in its route to
the destination are through interfaces other than the interface that received the ARP
request.
Default
Format
Mode
14.1.2.1 no ip proxy-arp
This command disables proxy ARP on a router interface.
Format
Mode
14-2
arp <ipaddress> <macaddr>
Global Config
is the IP address of a device on a subnet attached to
<ipaddress>
is a unicast MAC address for that device.
<macaddr>
no arp <ipaddress> <macaddr>
Global Config
enabled
ip proxy-arp
Interface Config
no ip proxy-arp
Interface Config
v1.0, December 2005
is the IP address of a
<ipaddress>
is a unicast MAC
<macaddr>
is the IP address of the
<arpentry>
Routing Commands