Area Nssa Translator-Stab-Intv; Area Range; Area Stub - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Mode

14.6.11 area nssa translator-stab-intv

This command configures the translator
<stabilityinterval>
its duties after it determines that its translator status has been deposed by another router.
Format
Mode

14.6.12 area range

This command creates a specified area range for a specified NSSA. The
valid IP address. The
specified by either
range can be allowed or suppressed.
Format
Mode
14.6.12.1 no area range
This command deletes a specified area range.
Format
Mode

14.6.13 area stub

This command creates a stub area for the specified area ID. A stub area is characterized by
the fact that AS External LSAs are not propagated into the area. Removing AS External
LSAs and Summary LSAs can significantly reduce the link state database of routers
within the stub area.
Format
Mode
Routing Commands
Router OSPF Config
<stabilityinterval>
is the period of time that an elected translator continues to perform
area <areaid> nssa translator-stab-intv <stabili-
tyinterval>
Router OSPF Config
is a valid subnet mask. The LSDB type must be
<subnetmask>
or
summarylink nssaexternallink
area <areaid> range <ipaddr> <subnetmask> {summa-
rylink | nssaexternallink} [advertise | not-adver-
tise]
Router OSPF Config
no area <areaid> range <ipaddr> <subnetmask>
Router OSPF Config
area <areaid> stub
Router OSPF Config
v1.0, December 2005
of the NSSA. The
<ipaddr>
, and the advertising of the area
is a
14-33