Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
14.6.17.1 no area virtual-link dead-interval
This command configures the default dead interval for the OSPF virtual interface on the
virtual interface identified by
the Router ID of the neighbor.
Format
Mode
14.6.18 area virtual-link hello-interval
This command configures the hello interval for the OSPF virtual interface on the virtual
interface identified by
Router ID of the neighbor. The range for
Default
Format
Mode
14.6.18.1 no area virtual-link hello-interval
This command configures the default hello interval for the OSPF virtual interface on the
virtual interface identified by
the Router ID of the neighbor.
Format
Mode
14.6.19 area virtual-link retransmit-interval
This command configures the retransmit interval for the OSPF virtual interface on the
virtual interface identified by
the Router ID of the neighbor. The range for
Default
Format
Mode
14-36
and
<areaid>
<neighbor>
no area <areaid> virtual-link <neighbor> dead-
interval
Router OSPF Config
and
<areaid>
<neighbor>
<seconds>
10
area <areaid> virtual-link <neighbor> hello-inter-
val <1-65535>
Router OSPF Config
and
<areaid>
<neighbor>
no area <areaid> virtual-link <neighbor> hello-
interval
Router OSPF Config
and
<areaid>
<neighbor>
5
area <areaid> virtual-link <neighbor> retransmit-
interval <0-3600>
Router OSPF Config
v1.0, December 2005
. The
<neighbor>
. The
<neighbor>
is 1 to 65535.
. The
<neighbor>
. The
<neighbor>
is 0 to 3600.
<seconds>
parameter is
parameter is the
parameter is
parameter is
Routing Commands