Show Mstat; Show Mtrace - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Flags

15.1.18 show mstat

This command is used to display the results of packet rate and loss information from the
results buffer pool of the router, subsequent to the execution/completion of a
<source> [group] [receiver]
command, the results will be available in the buffer pool. The next issuing of
mstat
overwrites the buffer pool with fresh results.
Default
Format
Mode

15.1.19 show mtrace

This command is used to display results of multicast trace path from the results buffer pool
of the router, subsequent to the execution/completion of a
command. The results subsequent to the completion of the
[receiver]
available in the buffer pool within two minutes and thereafter. A subsequent
command overwrites the results in the buffer pool.
Default
Format
Modes
Hops Away From
Destination
Intermediate
Router Address
Mcast Protocol In
Use
TTL Threshold
IP Multicast Commands
Status of the neighbor
command. Within two minutes of the completion of the
none
show mstat
Privileged EXEC
none
show mtrace
Privileged EXEC
User EXEC
The ordering of intermediate routers between the source and
the destination
The address of the intermediate router at the specified hop
distance
The multicast routing protocol used for the out interface of
the specified intermediate router.
The Time-To-Live threshold of the out interface on the speci-
fied intermediate router.
v1.0, December 2005
mstat
mtrace <source> [group]
mtrace
mtrace
mstat
will be
15-11