Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Time Elapsed
Between Hops
(msecs)
15.2 DVMRP Commands
This section provides a detailed explanation of the Distance Vector Multicast Routing
Protocol (DVMRP) commands.
15.2.1 ip dvmrp
This command sets administrative mode of DVMRP in the router to active. IGMP must be
enabled before DVMRP can be enabled.
Default
Format
Mode
15.2.1.1 no ip dvmrp
This command sets administrative mode of DVMRP in the router to inactive.
Format
Mode
15.2.2 ip dvmrp metric
This command configures the metric for an interface. This value is used in the DVMRP
messages as the cost to reach this network. This field has a range of 1 to 31.
Default
Format
Mode
15.2.2.1 no ip dvmrp metric
This command resets the metric for an interface to the default value. This value is used in
the DVMRP messages as the cost to reach this network.
Format
Mode
15-12
The time between arrival at one intermediate router to the
arrival at the next.
disabled
ip dvmrp
Global Config
no ip dvmrp
Global Config
1
ip dvmrp metric <
metric
Interface Config
no ip dvmrp metric
Interface Config
v1.0, December 2005
>
IP Multicast Commands