Show Logging Buffered; Show Logging Hosts; Show Logging Traplogs - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

18.3.9 show logging buffered

This command displays buffered logging (system startup and system operation logs).
Format
Mode
Admin Status
Component Filter
Wrapping
Behavior
Log Count

18.3.10 show logging hosts

This command displays all configured logging hosts.
Format
Mode
Host Index
Severity Level
Port
Host Status

18.3.11 show logging traplogs

This command displays SNMP trap events and statistics.
Format
Mode
Number of Traps
Since Last Reset
Trap Log
Capacity
System Maintenance Commands
show logging buffered
Privileged EXEC
The current state of the in-memory log.
The component(s) from which received messages are to be
logged to the in memory log. Either a single component id or
"all components" may be specified.
The behavior of the In Memory log when faced with a log
full situation.
The count of valid entries in the buffered log.
show logging hosts
Privileged EXEC
(Used for deleting hosts)
The minimum severity to log to the specified address.
Displays the server port number, which is the port on the
local host from which syslog messages are sent.
The state of logging to configured syslog hosts. If the status is
disable, no logging occurs.
show logging traplogs
Privileged EXEC
Shows the number of traps since the last boot.
Shows the number of traps the system can retain.
v1.0, December 2005
18-25