Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
14.8.58 redistribute
This command configures BGP protocol to redistribute routes from the specified source
protocol/routers. RFC 1745 requires that the BGP/IDRP identifier must be equal to the
OSPF router identifier at all times that the router is up. But in the current 7300 Series
Managed Switch implementation, these two can be different.
Default
Format for OSPF
as source
protocol
Format for other
source protocol
Mode
14.8.58.1 no redistribute
This command removes the configuration for the redistribution for BGP protocol from the
specified source protocol/routers.
Format
Mode
14.8.59 route-aggregation
This command enables the usage of path address aggregation. The possible values for this
field are
enable
Default
Format
Mode
14-90
metric - none; match - internal
redistribute ospf [metric <0-4294967295>] [match
[internal] [external 1] [external 2] [nssa-exter-
nal 1] [nssa-external-2]]
redistribute {rip | static | connected} [metric
<0-4294967295>]
Router BGP Config
no redistribute {ospf | bgp | static | connected}
[metric] [match [internal] [external 1] [external
2] [nssa-external 1] [nssa-external-2]]
Router BGP Config
and
disable.
disabled
route-aggregation
Router BGP Config
v1.0, December 2005
Routing Commands