Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
15.4.4.1 no ip pimsm message-interval
This command is used to reset the global join/prune interval for PIM-SM router to the
default value.
Format
Mode
15.4.5 ip pimsm
This command sets administrative mode of PIM-SM multicast routing across the router to
enabled. IGMP must be enabled before PIM-SM can be enabled.
Default
Format
Mode
15.4.5.1 no ip pimsm
This command sets administrative mode of PIM-SM multicast routing across the router to
the default value. IGMP must be enabled before PIM-SM can be enabled.
Format
Mode
15.4.6 ip pimsm mode
This command sets administrative mode of PIM-SM multicast routing on a routing
interface to enabled.
Default
Format
Mode
15.4.6.1 no ip pimsm mode
This command sets administrative mode of PIM-SM multicast routing on a routing
interface to the default value.
Format
Mode
15-22
no ip pimsm message-interval
Global Config
disabled
ip pimsm
Global Config
no ip pimsm
Global Config
disabled
ip pimsm mode
Interface Config
no ip pimsm mode
Interface Config
v1.0, December 2005
IP Multicast Commands