Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
14.8.2 aggregate-address
This command creates an address aggregation entry. The <
entry. The <
mask
added.
Default
Format
Mode
14.8.2.1 no aggregate-address
This command deletes an address aggregation entry. The <
entry.
Format
Mode
14.8.3 bgp addrfamily create
This command assigns the an Address Family with a Subsequent Address Family
Identifier (SAFI). The AFI identifies a supported protocol, and is defined as having the
value of IP version 4. The SAFI describes a sub-AFI value that is supported for the AFI.
The possible values for <
.
labeldist
Default
Format
Mode
14.8.3.1 no bgp addrfamily create
This command deletes the Address Family with the assigned Subsequent Address Family
Identifier (SAFI).TheAFI identifies a supported protocol, and is defined as having the
value of IP version 4. The SAFI describes a sub-AFI value that is supported for the AFI.
The possible values for <
Default
Format
Mode
Routing Commands
> is the netmask for the ip address. A maximum of ten entries can be
none
aggregate-address <prefix> <mask>
Router BGP Config
no aggregate-address <prefix> <mask>
Router BGP Config
> are
safi
unicast
none
bgp addrfamily create <safi>
Router BGP Config
are
unicast, multicast, both-unicast-multicast
safi>
none
no bgp addrfamily create <safi>
Router BGP Config
v1.0, December 2005
> is a valid IP address
prefix
> is a valid IP address
prefix
,
,
multicast
both-unicast-multicast
and
and
labeldist.
14-67