Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
14.8.4 bgp autorestart
This command informs the BGP4 module to enable automatic message sending in the case
of connection failure.
Default
Format
Mode
14.8.4.1 no bgp autorestart
This command informs the BGP4 module to disable automatic message sending in the
case of connection failure.
Format
Mode
14.8.5 bgp calcmedmode
This command informs the BGP4 module to enable or disable the use of the Calculated
MED attribute. The MED attribute is used to describe the degree of preference of a
particular link.
Default
Format
Mode
14.8.5.1 no bgp calcmedmode
This command informs the BGP4 module to disable (set to default) the use of the
Calculated MED attribute.
Format
Mode
14.8.6 bgp cluster-id
This command assigns the cluster ID to which the router belongs. The Cluster value is a
valid IP address.
Default
Format
Mode
14-68
disabled
bgp autorestart
Router BGP Config
no bgp autorestart
Router BGP Config
disabled
bgp calcmedmode
Router BGP Config
no bgp calcmedmode
Router BGP Config
0.0.0.0
bgp cluster-id <clusterid>
Router BGP Config
v1.0, December 2005
Routing Commands