Neighbor <Peeripaddr> Authentication Simple; Neighbor Confedmember; Neighbor Connretry - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
14.8.46 neighbor <peeripaddr> authentication simple
This command configures the authentication as simple password and the key for a
particular peer address. This is used in OPEN messages to authenticate the peer
connection. The key parameter must be less than16 characters long. After you execute this
command, reset the BGP peer for the changes to take effect.
Default
Format
Mode

14.8.47 neighbor confedmember

This command enables the peer as a member of the confederation. The possible values for
this field are
enable
for the changes to take effect.
Default
Format
Mode
14.8.47.1 no neighbor confedmember
This command disables the peer as a member of the confederation. The possible values for
this field are
enable
reset before the changes will take effect.
Format
Mode

14.8.48 neighbor connretry

This command specifies the connection retry interval in seconds for a peer. The range is 1
to 65535 seconds.
Default
Format
Mode
Routing Commands
none
neighbor <peeripaddr> authentication <simple>
[key]
Router BGP Config
and After you execute this command, reset the BGP peer
disable.
disabled
neighbor <peeripaddr> confedmember
Router BGP Config
and After executing this command, the BGP peer must be
disable.
no neighbor <peeripaddr> confedmember
Router BGP Config
120
neighbor <peeripaddr> connretry <1-65535>
Router BGP Config
v1.0, December 2005
14-85