NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual page 225

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Drop
Mark CoS
Mark IP DSCP
Mark IP
Precedence
Non-Conform
Action
Non-Conform
COS
Non-Conform
DSCP Value
Non-Conform IP
Precedence
Value
Policing Style
Redirect
If the Policy Name is not specified this command displays a list of all defined DiffServ
policies. The following fields are displayed:
Policy Name
Quality of Service (QoS) Commands
Drop a packet upon arrival. This is useful for emulating
access control list operation using DiffServ, especially when
DiffServ and ACL cannot co-exist on the same interface.
Denotes the class of service value that is set in the 802.1p
header of inbound packets. This is not displayed if the mark
cos was not specified.
Denotes the mark/re-mark value used as the DSCP for traffic
matching this class. This is not displayed if mark ip descrip-
tion is not specified.
Denotes the mark/re-mark value used as the IP Precedence
for traffic matching this class. This is not displayed if mark ip
precedence is not specified.
The current setting for the action taken on a packet consid-
ered to not conform to the policing parameters. This is not
displayed if policing not in use for the class under this policy.
This field displays the CoS mark value if the non-conform
action is set-cos-transmit.
This field displays the DSCP mark value if the non-conform
action is set-dscp-transmit.
This field displays the IP Precedence mark value if the non-
conform action is set-prec-transmit.
This field denotes the style of policing, if any, used (simple).
Forces a classified traffic stream to a specified egress port
(physical port). This can occur in addition to any marking or
policing action. It may also be specified along with a QoS
queue assignment.
The name of this policy. (The order in which the policies are
displayed is not necessarily the same order in which they
were created.)
v1.0, December 2005
13-25