Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
This set of commands consists of policy creation/deletion, class addition/removal, and
individual policy attributes.
Note: The only way to remove an individual policy attribute from a class instance
The CLI command root is
13.4.1 assign-queue
This command modifies the queue id to which the associated traffic stream is assigned.
The queueid is an integer from 0 to n-1, where n is the number of egress queues supported
by the device.
Format
Mode
Incompatibilities Drop
13.4.2 drop
This command specifies that all packets for the associated traffic stream are to be dropped
at ingress.
Format
Mode
Incompatibilities Assign Queue, Mark (all forms), Police
13.4.3 conform-color
This command is used to enable color-aware traffic policing and define the conform-color
class map. Used in conjunction with the police command where the fields for the conform
level are specified. The
class map.
Note: This command may only be used after specifying a police command for the
13-16
within a policy is to remove the class instance and re-add it to the policy.
The values associated with an existing policy attribute can be changed
without removing the class instance.
policy-map
assign-queue <queueid>
Policy-Class-Map Config
drop
Policy-Class-Map Config
<class-map-name>
policy-class instance.
v1.0, December 2005
.
parameter is the name of an existing Diffserv
Quality of Service (QoS) Commands