Distance Bgp; Distribute-List Out; Enable (Bgp) - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

14.8.41 distance bgp

This command sets the route preference value of BGP-4 routes in the router. Lower route
preference values are preferred when determining the best route.
Default
Format
Mode
14.8.41.1 no distance bgp
This command sets the default route preference value of BGP-4 routes in the router.
Format
Mode

14.8.42 distribute-list out

This command is used to specify the access list to filter routes received from the source
protocol.
Format
Mode
14.8.42.1 no distribute-list out
This command is used to specify the access list to filter routes received from the source
protocol.
Format
Mode

14.8.43 enable (BGP)

This command enables the administrative mode of BGP4 on the system.
Format
Mode
Routing Commands
170
distance bgp <1-255>
Router BGP Config
no distance bgp
Router BGP Config
distribute-list <1-199> out {rip | ospf | static |
connected}
Router BGP Config
no distribute-list <1-199> out {ospf | rip |
static | connected}
Router BGP Config
enable
Router BGP Config
v1.0, December 2005
14-83