Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
14.8.67 show ip bgp local
This command displays the local parameter information for the BGP4 object in the
system. You can configure all of the parameters in the output.
Format
Mode
Route Local
Origin
Route Local MED
Route Local
Preference
Suppress Mode
Route
Community
Address
Aggregation
Mode
14.8.68 show ip bgp mplslabels
This command displays the multi protocol label switching (MPLS) information.
Format
Mode
Prefix
Prefix Length
Peer ID
VPNCOS Id
14-96
show ip bgp local
Privileged EXEC
This displays the value of the Local Origin attribute for the
locally originated routes.
This displays the local multi-exit-discriminator value for the
BGP4 router.
This displays the Local Preference value used for the local
originating routes.
This indicates whether or not the selection of less-specific
routes is suppressed. If this is set to <
cific routes will be suppressed.
This field displays the local associated community used for
the locally originating routes.
This field states whether or not Address Aggregation is being
used.
show ip bgp mplslabels <prefix> <prefixlen>
<peerid> <vpncos>
Privileged EXEC
This is the prefix of this entry in the BGP4 route table.
This is the prefix length of this entry in the BGP4 route table.
This is the Peer ID for this entry in the BGP4 route table.
This is the VPN/CoS ID for this entry in the BGP4 route table
v1.0, December 2005
> then more spe-
enable
.
Routing Commands