Logout; Ping - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Table 18-1. Copy Parameters (continued)
Source
<url>
<url>
<url>
<url>
<url>
<url>
<url>
<url>

18.2.11 logout

This command closes the current telnet connection or resets the current serial connection.
Note: Save configuration changes before logging out.
Format
Mode

18.2.12 ping

This command checks if another computer is on the network and listens for connections.
To use this command, configure the switch for network (in-band) connection. The source
and target devices must have the ping utility enabled and running on top of TCP/IP. You
can ping the switch from any IP workstation the switch is connected to through the default
VLAN (VLAN 1), as long as there is a physical path between the switch and the
workstation. The terminal interface sends three pings to the target station.
18-20
Destination
nvram:sshkeyrsa1
nvram:sshkeyrsa1
nvram:sslpemroot
nvram:sslpemserver
nvram:sslpemdhweak
nvram:sslpemdhstron
g
nvram:startup-config
system:image
logout
Privileged EXEC
v1.0, December 2005
Description
Downloads an SSH key file.
Downloads an SSH key file.
Downloads an HTTP secure-server
certificate. For more information, see
Section 3.5 "Hypertext Transfer
Protocol (HTTP) Commands" on
page 3-15.
Downloads an HTTP secure-server
certificate.
Downloads an HTTP secure-server
certificate.
Downloads an HTTP secure-server
certificate.
Downloads the startup configuration
file to the system.
Downloads a code image to the
system.
System Maintenance Commands