Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
14.8.55.1 no neighbor timers
This command specifies the default keep alive and hold time for a peer. After executing
this command, the BGP peer must be reset before the changes will take effect
Format
Mode
14.8.56 neighbor txdelayint
This command configures the delay interval between two transmission sessions of
MsgSendLimit packets. The range for this field is 1 to 5
Format
Mode
14.8.56.1 no neighbor txdelayint
This command configures the default delay interval between two transmission sessions of
MsgSendLimit packets.
Format
Mode
14.8.57 network
This command adds network layer reachability information (NLRI) to the BGP4 Router.
The NLRI field contains a list of network numbers being advertised. The network number
is a valid IP address entry. The
prefix should be sent. The <
You can add a maximum of ten NLRIs.
Default
Format
Mode
14.8.57.1 no network
This command removes NLRI (Network Layer Reachability Information) from the BGP4
Router. The Network number is a valid IP address entry.
Format
Mode
Routing Commands
no neighbor <peeripaddr> timers
Router BGP Config
neighbor <peeripaddr> txdelayint <1-5>
Router BGP Config
no neighbor <peeripaddr> txdelayint
Router BGP Config
[send | donotsend]
field allows assignment of the VPN/CoS identifier.
vpncos>
none
network <networknumber> [mask <networkmask> [<vpn-
cos> [<nexthop> [send | donotsend]]]]
Router BGP Config
no network <networknumber> [mask <networkmask>]
Router BGP Config
v1.0, December 2005
.
field indicates whether or not this
14-89